The Next Qualified Level Arc Flash Safety Training Webinars Scheduled for July 29, 2021

July 1, 2021

Make sure your service techs have the up-to-date safety training they need to protect themselves from arc flash and electrical shock hazards while working on equipment pushing 480 volts or less. The session covers all applicable OSHA requirements, NFPA 70E provisions, best practices, and real-world accident information.

VIEW BROCHURE

The next two webinars will be presented on July 29, 2021. The first webinar will take place from 7:00 a.m. – 9:00 a.m. ET, and the second is from 10:00 a.m. – 12:00 p.m. ET.

REGISTER TODAY

Take advantage of the MCAA/MSCA member discounted webinar prices below.

PRICING:

# of Trainees (per company)Cost (per person)
1-5$200/person
6-10$175/person
11-25$150/person
26-50$125/person
51-100$100/person
101+Email for Pricing

If you can’t make it in July, the webinar will be taught again twice on August 26, 2021. Questions? Contact Pete Chaney.

Related Articles
OSHA recently updated their guidelines on mitigating and preventing the spread of COVID-19 in the workplace, which reflects the July 27, 2021 Centers for Disease Control and Prevention (CDC) mask and testing recommendations for fully vaccinated people.…
Each week, MCAA will highlight one or more of the educational resources that are free to MCAA members as a benefit of membership. This week, we focus on MCAA’s new safety training video, Master the Mechanics: Hand & Power Tool Safety for the Mechanical Trades. The video provides trainees with information on the most common hand and power tool injuries in the mechanical construction and service trades. It highlights the tools most likely to be involved in an injury incident, and teaches proper use of the tools to help prevent injuries.…
MCAA extends a warm welcome to Raffi Elchemmas, who will be joining the staff starting August 2, 2021. He will be MCAA’s new Executive Director of Safety, Health and Risk Management, learning the ropes before Pete's upcoming retirement. Raffi comes to us from Milwaukee Tool, where he was the National Manager, Health & Safety. He is a board-certified ergonomist with an MBA in Sales Leadership & Health Sector Management from DePaul University. He has been a member of MCAA’s Safety and Health Committee since 2019. MCAA is pleased to welcome Raffi to the staff, and his wife Martha, daughter Nina, and son Vartan to the MCAA staff family.…
STIHL is recalling to repair certain TS 410 and TS 420 cut-off machines manufactured between January 2021 and April 2021. In some of these machines the flywheel can break apart while the engine is running, posing a projectile hazard to the users or bystanders. If you have any of these machines, immediately discontinue use and take them to an authorized STIHL dealer for free repair. …
Load More...